By Carl Ariya
If you are passionate about wine, you should know that storing it is essential to its taste. Not only is a VintageView wine rack a beautiful and modern way to display your collection, but it also makes it simple to see, grab and add the perfect bottle to your collection below. But if you fear installing it because the process will be a hassle or complicated, fear not! You can set it up neatly and efficiently with simple steps and the right tools. Here are step-by-step instructions to help you do it without getting into a mess.
Choose the Perfect Spot
Before you get started, give some thought to where you should mount your rack. These VintageView metal wine racks look fantastic in kitchens, dining rooms or home bars. Pick a flat, solid wall that doesn’t get too hot or humid — wine loves cooler, consistent weather.
If you’re attaching to drywall, find the studs with a stud finder for better support. For brick or concrete walls, you will need special anchors. Pre-planning for the location can save time and avoid unnecessary holes or drilling.
Collect Your Tools
Nothing will slow an installation down, such as running for missing tools. Here’s a simple checklist to ensure you’re prepared:
- Drill and drill bits
- Level
- Measuring tape
- Screwdriver
- Pencil or marker
- Wall anchors (if needed)
- Hardware to mount (rack comes with it)
With everything in one place, you can keep your workspace organised and your setup easy.
Mark the Wall Carefully
Now, the most critical part is marking your holes properly. Use a tape measure to mark the locations for placing each rack column or panel. (VintageView includes a mounting guide in the box or can be downloaded from its website, making it even easier.)
Lightly mark the spots you will drill with a pencil. Double-check to make sure everything is level and evenly spaced. Taking a few minutes at this stage can ensure that the racks aren’t crooked or the lines aren’t uneven later — and you’ll come away with fewer extra holes in your wall!
Drill With Intelligence — No Dust, No Mess
Drilling can be messy, but here’s a tip to contain it:
- Hold a folded sticky note or a piece of small paper under the point you are drilling to catch the dust.
- You can also hold a vacuum with your other hand right below the drill to suck in all of the dirt, dust and debris immediately.
This little gesture goes a long way in cleaning up and maintaining your immaculate floor.
For drilling into drywall, ensure you use the right-sized bit for the wall anchors. For concrete or brick, use a masonry bit. Drill slowly and steadily to prevent cracking or damage on the drilling surface.
Install Anchors and Mounting Brackets
After you have your holes, put your wall anchors in (if you aren’t drilling right into studs). Among other functions, these anchors help your rack stay put. Then add the mounting brackets with the supplied screws.
After that, use your level again to check for straightness — this is the most important thing to do if you want a clean, professional look. Secure the screws, but don’t tighten them down too hard, or you risk damaging the wall or rack.
Final Thoughts
Putting in a VintageView rack doesn’t have to be messy or complicated. By thinking ahead, you can avoid creating a mess while getting your rack up and ready in no time with just a few simple tools and a steady hand.
Whether showcasing your limited-edition collection or creating a whole wall of wine, these racks contribute major elegance and organisation to your area. So, get your tools ready, pour yourself a glass of wine from the bottle without having to work up a sweat finding it, and in no time, you’ll be staring admiringly at your tidy wine display — no spills, dust, or mess!
